Dalsey Adaptives

General Instructions

• Keep black battery case dry.
• Leave protective cover on black battery case at all times. Move the on/off switch with finger on outside of latex cover.
• Replace protective covers if ripped or torn.
• Wet the bottom of the plunger with sterile saline and insert the LED bulb in the small hole with a twisting motion.
• Cover the black battery case with a paper towel or small cloth towel when in use.
• Before using, always wet the tip of the plunger with sterile saline. Do not apply a dry plunger to the lens surface.
• After use, clean tip of plunger, end of plunger and LED bulb with alcohol pad.
• Dry off wire/LED bulb prior to storage.

Precautions

• Use plunger light inserter for insertion only.
• Do not use to remove lens.
• Wash hands thoroughly with soap (without moisturizer) and water, and dry before handling plunger and light.
• Covers contain latex. if you have latex allergies ontact us for alternative covers.

Use Instructions

• Overfill the lens with Unisol to improve your chances of a bubble free insertion.
• The lid spread is everything! Hold the lids by the margins, where the lashes meet the lids.
• The contact points should be centered so as to form a perfect circle. Hold both lids open.

1. Tuck your chin to your chest. Look straight down. Keep the plunger centered on your eye by focusing on the lighted hole. Continue approaching your eye smoothly and steadily. You will feel the fluid but you are not there yet. Press the lens onto the eye with firm pressure.
2. Capture the device with the eyelids by releasing the lids. Don’t squint. Maintain the upward pressure on the lens.
3. Release the lens from plunger by squeezing completely. Maintain the upward pressure against the eye, while squeezing to release the lens. Do a “Push Squeeze”
   The device has now been released onto your eye.
   Stay squeezed while you retract the plunger away from the eye.